Skip to content

Zennio 160mA KNX power supply (max. 250 mA)-ZPSU160

Ref.: ZPSU160

Zennio

Availability: In Stock Out of stock
Special Price: 138.00 € Regular Price: 129.00 €

Zennio 160mA KNX power supply  (max. 250 mA)-ZPSU160(2 DIN rail units)

Power supply KNX 160mA with 29VDC auxiliary power supply

  • KNX system power source with additional 29VDC output.
  • Supply voltage 230V~ 50/60Hz.
  • Maximum consumption of KNX BUS line 160mA.
  • Maximum additional 29VDC output consumption of 250mA -
  • KNX coil included.
  • Mounting on DIN rail (EN 50022), pressure mounted.
  • Protection against short circuit and overvoltage.
  • Reset button and overload status LED.
  • Complies with CE directives.

Count 10mA per KNX participant to choose a KNX power supply.

Safety instructions:

  • The installation must be equipped with a device that ensures omnipolar disconnection. A 10A circuit breaker is recommended.
  • Do not connect the main network voltage or other external voltages to the KNX data bus or to the additional output.
  • Connecting an external voltage may endanger the electrical safety of the entire KNX system.
  • Always check during installation that there is sufficient insulation between the conductors of the 230V main voltage and the conductors of the Bus and its extensions.
  • Do not cover the ventilation grilles to prevent the temperature acceptable to the device from being exceeded.
  • Caution! Once the device has been installed, it must not be accessible from the outside.
  • The electrical equipment must only be installed by qualified electricians and in accordance with accident prevention regulations.
  • To prevent electrical accidents, before working on the unit, disconnect the main power supply with the circuit breaker located upstream of the unit.
  • Failure to follow the installation instructions may cause damage to the installation.

  • Width (nb of DIN rail modules) : 2
  • Weight : 0.2
Add your comment
Only customer are allowed to publish comment
Comments