Zennio LUMENTO x4 ZN1DI-RGBX4

Main characteristics:

• programmable product with ETS5
• LED control (24 volts) RGB/White on 4 independent channels.
• Requires an external 24VDC, 10A power supply. Possibility to supply 12VDC in specific cases.
• Possibility of dimming, switching on with intensity and preset color.
• ON/OFF function. LED test function.
• Integrated KNX bus coupling unit (BCU).
• KNX and CE marked.

Safety instructions and warnings :

• Do not connect the main voltage (230V) or other external voltages to the KNX Data Bus. Connecting an external voltage may endanger the electrical safety of the entire KNX system.
• Always check during installation that there is sufficient insulation between the 230V main voltage conductors and the conductors of the bus and its extensions.
• If the overheating protection trips, the device will reduce the illumination level (50%) and the control frequency. For more information, see the manual.The voltage of the power source connected to the Lumento must never exceed the supply voltage specified by the manufacturer of the load to be tested, as this may damage the load.