Zennio KCI 4 S0 KNX interface for Consumption Meters ZRX-KCI4S0

KCI (KNX Consumption Interface) is the Zennio KNX interface for four consumption meters with S0-pulse outputs to monitor their electricity (energy and power), water and/or gas (volume and flow rate) consumption measure in the KNX bus. A removable battery allows buffering S0 pulses during a KNX power failure and recovering the real consumption afterwards. LED indicators make the user able to check the existence of communication through each S0 channel, as well as the battery status (low battery and/or run out of battery), which is also indicated in the KNX bus. DIN-rail mounting device (2 DIN-rail units).

Zennio-KEM-KNX Energy Monitor-ZEMKEM

KNX Energy Monitor for electricity and water consumption, as well as heating/cooling energy consumption for up to 2 climate systems. It has 3 channels to monitor electricity consumption (max 20 A), 4 channels to connect turbine flow meters (max 15 mA at 5 VDC) and 5 analog-digital inputs to connect flow and return water temperature probes. It also includes 10 logical functions, consumption dependent notifications and alarms. The 5 VDC power output can supply power for the connected flow meters . DIN-rail mounting device (4.5 DIN-rail units).

Zennio KES Plus KNX Electrical energy meter ZIO-KESP

 Up to 60A measurement per phase, requires the use of : Zennio 60A current transformer ref: ZN1AC-CST60

Up to 120A measurement per phase, requires the use of : Zennio 120A current transformer ref: ZN1AC-CST120

The nominal phase measurement current is 260A (see data sheet documentation), require the use of :

Zennio Current transformer 600A ref: 9900045

• Measurement of main electrical magnitudes.
• Suitable for 3-phase 4-wire or single-phase installations (3 lines).
• Power measurement (W or kW) and Energy with 3 registers.
• Currency and CO2 emissions estimation registers.
• KNX system clock synchronization is allowed.
• Up to 6 tariff cost-counters.
• Total data saving on KNX bus failure.
• Integrated KNX BCU.
• Dimensions 67 x 90 x 35mm (2 DIN units).
• DIN rail mounting (EN 50022), through pressure.
• Conformity with the CE directives (CE-mark on the right side).