﻿The actuator permits setting of the reaction separately for each switching output after an ETS programming operation.

*Close contact*: The relay contact closes after an ETS programming operation

*Open contact*: The relay contact opens after an ETS programming operation

*no reaction*: After ETS programming, the relay of the output shows no response and remains in the switching state last selected. The internal logical switching state is not lost by the ETS programming operation.

*as with bus voltage return*: After an ETS programming operation, the switching output will behave in the manner defined in the parameter "After bus voltage return". If the behaviour there is configured to "state as before bus voltage failure", then that switching state is also set after an ETS programming operation which was active at the time of the last bus voltage failure. An ETS programming operation does not overwrite the saved switching state.
