﻿#Manual operation

This parameter page contains the parameters for manual operation of the device.
All outputs of the device have electronic manual operation. The button field with 4 function buttons and 3 status LEDs on the front panel of the device can be used for setting the following modes of operation:

* Bus control: operation from touch sensors or other bus devices.

* Temporary manual control: manual control locally with keypad, automatic return to bus control.

* Permanent manual control: local manual control with keypad.

***

Manual control is possible while the device is supplied with power from the bus supply voltage. In the state as supplied the manual control mode is fully enabled. In this unprogrammed state, all outputs are set to blinds operation and can be controlled by the manual operation so that fast function checking of the connected loads (e.g. on the construction site) is possible

After initial commissioning of the actuator via the ETS, manual control can be enabled or completely disabled.
